German HD+ Nagra 3 Card don´t work

[Fan_da_patrick]

I already have two F16 (One White and One new Blue Edition)

I would like to use my HD+ Card in my cardreader, but it doesn´t work and is showed "invalid Smartcard".
Till FW 2.15 it is read as Nagravision but no picture.
In other HDTV receivers like Clarketech or Vantage it works with no problems.

Please integrate the support for the Card in next Firmware.

Thanks very much

So my F16 will better fly in future with this Card

[ramul.wasi]

ClarkeTech from the same manufacturer, the HD + card works fine!
Why not for the F16?
It must be possible to ask the manufacturer but also to integrate the fix in F16?

Thank you

[ramul.wasi]

HD+ CARD Works now in Cardreader!

THANKS SO MUCH Programmer

[Fan_da_patrick]

Exactly 1 Week my HD+ Card works in Cardreader perfect with no problems.
Since Yesterday all 20 minutes Picture stands.
I must remove card and reenter, than it works again for exact 20minutes.

In other Receiver i have tested, there is no problem.

So i hope that you will find the problem and fix in next Firmware.

[ramul.wasi]

@fan_da_patrick

Also the same problem here

I don´t know why 1 week it works near perfect...

So i hope for fix

[Fan_da_patrick]

It seems as if not all updates are transmitted to the card, and it so comes to the problems! For after I have the card in the HD + Diablo 2 again updated, it works in F16 again properly.

It would be great if you can eliminate the problem.

[Wladimir.solo]

With firmware 2.25p HD + Nagra card shown as "invalid smartcard" No Function.
With the card FW 2.24p worked 1 week, then stops image.
It seems as if not get through all the updates to the map.

Please dear programmers, hoping to fix in FW 2.26p.

Thank you very much

[ramul.wasi]

HD+ Card don´t work in FW 2.26p or 2.27p....

Somebody the same

[Fan_da_patrick]

FW 2,26p or 2.27p

After starting the receiver, the HD + Nagra 3 card is recognized as invalid smart card!
If one then takes the card and pocketed new, it works!
At the next reboot of the receiver, again the same!

Hope to fix!

[ramul.wasi]

HD+ Card now works in Firmware 2.28p with no freezers, but on restart receiver the card shown as invalid smartcard!
The same problem as fan_da_patrick!

So hope for fix in next Firmware.

Thanks so much for the work